Fusible single sided Foam Stabilizer In-R-Form, 2 1/4" x 20 yds (5,8 cm x 18,2 m), Bosal 495S-20 NewCondition

Interfacing & Stabilizer. Ideal for bag making, purse making, laptop/mobile phone cover making, for table textile etc...

Always test fuse the selected fabric and the selected fusible interfacing prior to start of any project.
Important for a successful bond: time, temperature and pressure.
1) Time always depends on the thickness of the fabric and how much heat you are applying.
2) Temperature: Remember the resin or glue on fusible will draw towards a strong heat source. Use the maximum what is possible. The project should be able to withstand the temperature for
at least 8-12 seconds.
3) Pressure: When applying the iron use a downward pressure for 8-12 seconds. If the fabric is heavier/thicker, you may need to use a higher temperature and more time.
If the fabric is a synthetic or silk, use less time and a lower temperature with less pressure to prevent burning or scorch marks.
Do not glide the iron when fusing. Use a press and lift motion with very little overlap.
To  help achieve the proper bond always use steam and moisture, or a misted pressing cloth to protect the fabric.
 

Troubleshooting
Bubbling on one side of fabric - Fabric and Interfacing need preshrinking

Bubbling on both sides of fabric - Heat is too high - lower iron temperature

Poor bond - Fabrics are not compatible; fabrics are water repellent or stain guarded
Poor bond - Heat is too low - raise iron temperature, increase pressure and pressure time.

Take a look how to cover Bosal-strips with fabric HERE

... and how to use fabric covered strips HERE

Made in: USA